Electromagnetic Chuck Controls

SD Series Automatic Control

SD Series Automatic Control

The SD Series automatic controls are used when greater chuck demagnetization is required and for those chucks with high wattage ratings. The main enclosure can be located at the rear of the machine or wall mounted. The chuck is operated from a small remote control unit (4-1/2" x 6-1/2"x 4") located at the front of the machine which includes the "ON-OFF" control switch, red and green indicating lamps and the variable power control. The green lamp indicates the chuck is ready to accept or remove the part. The red lamp indicates the chuck is magnetized. When the control switch is turned off, the red lamp diminishes in intensity until it goes out leaving only the green lamp on. The operator can then remove the part with ease. The variable power control provides 0 to 100% power.

The NT and MA Series can also be used to operate smaller electromagnetic chucks where a single pulse release cycle is adequate.

Ordering Information

Request a Quote

110 VDC or 230 VDC Output - 240/480 VAC Input
Model #'s Watts Size in Inches
SD-110-300VP SD-230-300VP 300 16 x 20 x 7
SD-110-500VP SD-230-500VP 500 16 x 20 x 7
SD-110-750VP SD-230-750VP 750 16 x 20 x 7
SD-110-1000VP SD-230-1000VP 1000 16 x 20 x 9
SD-110-2000VP SD-230-2000VP 2000 20 x 24 x 11
SD-110-3000VP SD-230-3000VP 3000 20 x 24 x 11
Electromagnetic Chuck Controls

The CC Series is a self contained Electromagnetic Chuck Control for use with 110 VDC chucks up to 500 Watts. It features an eight pulse release cycle, indicating lamps, variable output power, residual hold-feature, 6 foot input cord with plug, 3 foot stub output cord and a provision for spindle interlock. Enclosure size: 8 inches x 10 inches x 6-1/2 inches deep.

Model #'s Input Output Watts
CC-110-150VP 120 VAC 110 VDC 150
CC-110-300VP 120 VAC 110 VDC 300
CC-110-500VP 120 VAC 110 VDC 500